159 how to install a shower drain[/caption]how to install a shower drain properly and easily. Specify the placement of bathroom furniture.
You should make sure the position of the bathtub or shower, and sink and the toilet. This will determine the placement of the system of waterways.
You later have to make holes in the floor to connected to the pipe. Therefore, it is very important to determine the position accurately bathroom furniture.
Determine and mark the point that you will cut and hole.
Measure again all point to ensure reliability. Remember, the words of the wise man, "you can measure twice, but could only cut once."
Do the cutting and create a hole in the position you've specified. Make sure you've done the preparation before turning off the water in the House so that your House is not experiencing "local drought" is too long.
Turn off the water.
Before tinkering with the plumbing, you must close the bathroom water flow. Search position faucet drains into the bathroom and close the tap.
Plug the drains.
For the standard bathroom, you need 5 aqueducts: two pairs of channels of hot and cold water to the tub/shower and sink, and funnels cold water to the toilet.
You can put a channel of water passing through the wall or on the floor, depending on the location of the bathroom.
Install flexible pipe to connect the cold and hot water channel with a bathtub faucetand sink.
Use sand paper to smooth copper pipe, then stained with water main pipe.
Connect the drain.
You need a different size the exhaust pipe to the bathroom. The drain for the toilets in diameter 3 inches (7.62 cm) or 4-inch (10.16 cm). After you install the drain pipe to the toilet, the position of the pipes should be decreased towards the main sewer. The exhaust pipe to the sink, use a pipe measuring 1.5 inches (3.81 cm) and for bathtub use size 2 inches (5.08 cm).
Install the toilet. The toilets usually consists of 2 parts: water tank and is part of the holder. Start by installing the parts of the holder.
Connect the exhaust pipe from the closet flange with a closet. To do this, paste it oncloset flange with glue in the right position so that its slot is in a straight position with the closet bolts with holes.
Attach and install the bolts that connect the holder with the closet flange. To make sure the holder is mounted perfectly, you can try to sit on the toilet and wiggle it a little to the front and rear.
Check that the holder has not been slanted, then tighten the nut and bolt ring for the closet.
Connect the water tank and stand, closet using nuts.
Connect the drains then PuTTY basic closet to keep it easy to shake.
Install the sink. Start by positioning the legs sink to fit its position.
Mark the position of the bolt floor and create a hole pierced feet sink and install the sink legs to the floor using nuts and bolts.
Connect the sink with cold water and hot water. Connect also the tap, stopper, and the exhaust vent in the top of the sink.
Install the sink onto his feet and attach the exhaust adapter screw the exhaust pipe to the sink.
Connect the tub with shower.
Mark the position of the tub on the floor so you can estimate the position of the drain.
Pull the drain and exhaust holes match the bathroom.
When it is straight, connect the drain and drain.
Install the tub and make sure it is not skewed.
No comments:
Post a Comment